Search: Posts Made By: Skinny Bob
Showing results 1 to 25 of 500
Search took 0.45 seconds.
Forum: Kit Building 10-03-2016, 04:16 PM
Replies: 19
Views: 1,252
Posted By Skinny Bob
Mark, that Nieuport is flat out beautiful, I see...

Mark, that Nieuport is flat out beautiful, I see in your photo's you are a body man, nice paint both!
Bob
Forum: Kit Building 10-03-2016, 04:09 PM
Replies: 1,675
Views: 90,219
Posted By Skinny Bob
Sounds good John, I going to use a 20X6 prop on...

Sounds good John, I going to use a 20X6 prop on mine, probably a bit much but, the AGM 30 can handle it OK and I like lots of power. :D
Bob
Forum: Kit Building 10-03-2016, 12:00 PM
Replies: 1,675
Views: 90,219
Posted By Skinny Bob
Hi John, welcome aboard. I'm building a BUSA Cub...

Hi John, welcome aboard. I'm building a BUSA Cub and using a AGM 30cc Also and would like to keep in touch with you about the engine, I haven't ran my AGM yet and won't until spring. Hope your build...
Forum: Kit Building 10-03-2016, 06:39 AM
Replies: 1,675
Views: 90,219
Posted By Skinny Bob
I am building a 1/4 scale BUSA J3 Cub and have...

I am building a 1/4 scale BUSA J3 Cub and have found that LustreKoat Cub Yellow has very little pigment and takes many many coats to cover, my solution was apply safety yellow first which is a...
Forum: Kit Building 10-01-2016, 03:39 PM
Replies: 1,675
Views: 90,219
Posted By Skinny Bob
Put me on the list also, I'm building the J3 Cub...

Put me on the list also, I'm building the J3 Cub with a AGM 30cc engine. Hope to have her in the air next season. Looking forward to seeing what others are doing with the Cub.
Skinny Bob
Forum: Questions and Answers 09-10-2016, 05:28 PM
Replies: 1
Views: 230
Posted By Skinny Bob
DLE or AGM Carb

Can someone give my a Walbro WT carb # for a DLE/AGM 30cc that has a detented open/close choke shaft, not even Walbro gives that info on their site, hard to believe!
Thanks
Bob
Forum: Gas Engines 05-01-2016, 02:48 PM
Replies: 29
Views: 2,498
Posted By Skinny Bob
I read most of the posts here, not sure if you...

I read most of the posts here, not sure if you checked the fuel pump diaphragm lever setting. My 20 came with the Chinese Webra clone carb, I had bad low end run and could not get an idle speed of...
Forum: AMA Discussions 02-21-2016, 07:04 PM
Replies: 5,254
Views: 176,612
Posted By Skinny Bob
I have a dumb question, I fly at my local airport...

I have a dumb question, I fly at my local airport with permission from the manager as long as I am a AMA member and have someone with me to watch for any full size air traffic on approach. Is it up...
Forum: AMA Discussions 02-19-2016, 05:50 PM
Replies: 5,254
Views: 176,612
Posted By Skinny Bob
Thanks for your help, I went there a couple days...

Thanks for your help, I went there a couple days ago and registered with the FAA and received my UAS certificate of registration. I guess I was confused because I was notified by the AMA and thought...
Forum: AMA Discussions 02-16-2016, 08:00 PM
Replies: 5,254
Views: 176,612
Posted By Skinny Bob
I have looked at the AMA web site to register my...

I have looked at the AMA web site to register my aircraft, however there is no where to register my fixed wing aircraft, only drones. Once again the educated people who write the instructions have...
Forum: AMA Discussions 02-11-2016, 06:24 PM
Replies: 5,254
Views: 176,612
Posted By Skinny Bob
Jimmy, I agree, they have my AMA number, is that...

Jimmy, I agree, they have my AMA number, is that not enough?
Forum: AMA Discussions 12-22-2015, 10:51 AM
Replies: 168
Views: 6,836
Posted By Skinny Bob
Aren't the drone people the ones that live under...

Aren't the drone people the ones that live under the bridge?
Forum: AMA Discussions 12-18-2015, 07:21 PM
Replies: 5,254
Views: 176,612
Posted By Skinny Bob
OK everyone, why do most of us belong to the...

OK everyone, why do most of us belong to the AMA?, INSURANCE! right? This may sound stupid to a lot of you but, what if someone who knows of a law firm who might consider covering the membership with...
Forum: AMA Discussions 11-19-2015, 06:32 PM
Replies: 84
Views: 3,770
Posted By Skinny Bob
I don't have any guns on my planes.

I don't have any guns on my planes.
Forum: Giant Scale Aircraft - General 10-18-2015, 05:31 PM
Replies: 0
Views: 464
Posted By Skinny Bob
Dario Brisighella Skybolt Plans

Dario Brisighella Skybolt Plans
I have plans for the Dario...
Forum: AMA Discussions 10-18-2015, 03:29 PM
Replies: 5,254
Views: 176,612
Posted By Skinny Bob
Nor will I !!! Bob

Nor will I !!!
Bob
Forum: AMA Discussions 05-28-2015, 04:38 PM
Replies: 188
Views: 6,413
Posted By Skinny Bob
Keep it up, and we will all pay more. Just leave...

Keep it up, and we will all pay more. Just leave it alone and up to the AMA.:confused:
Forum: Kit Building 04-02-2015, 11:17 AM
Replies: 4,155
Views: 248,428
Posted By Skinny Bob
John I kind of resemble that Skinny Bob alien,...

John I kind of resemble that Skinny Bob alien, could be a distant relative :rolleyes:
Forum: Kit Building 04-02-2015, 07:39 AM
Replies: 4,155
Views: 248,428
Posted By Skinny Bob
John_M_, never been there, I don't think they...

John_M_, never been there, I don't think they allow cub's near the place.:D

Bob
Forum: Kit Building 04-01-2015, 01:24 PM
Replies: 4,155
Views: 248,428
Posted By Skinny Bob
I would like to join the club also, I just...

I would like to join the club also, I just acquired a 1/4 scale L-4 complete except engine and receiver, a 1/4 scale J-3 complete except engine and receiver and servo's, a 1/4 scale J-3 kit that has...
Forum: Engine Conversions 02-28-2015, 01:50 PM
Replies: 124
Views: 15,411
Posted By Skinny Bob
Thanks for the help and info. bob

Thanks for the help and info.

bob
Forum: Engine Conversions 02-28-2015, 12:07 PM
Replies: 124
Views: 15,411
Posted By Skinny Bob
Thanks for the reply, I was given a Super Tiger...

Thanks for the reply, I was given a Super Tiger S3000, a fuel guzzler, and from what I have been able to learn on the forum's the ST S3000 run's best with 12% caster, 100% alcohol and 0% nitro. So...
Forum: Engine Conversions 02-28-2015, 06:40 AM
Replies: 124
Views: 15,411
Posted By Skinny Bob
I sure would like to have your formula, would you...

I sure would like to have your formula, would you share it?

Bob
Forum: Engine Conversions 02-26-2015, 03:29 PM
Replies: 124
Views: 15,411
Posted By Skinny Bob
With glow fuel reaching 80 to 90 bucks a gallon...

With glow fuel reaching 80 to 90 bucks a gallon who wouldn't switch??????

Bob
Forum: RC Scale Aircraft 02-20-2015, 02:56 PM
Replies: 164
Views: 26,585
Posted By Skinny Bob
Hi Adam, I just acquired a 1/4 scale J-3 and a...

Hi Adam, I just acquired a 1/4 scale J-3 and a L-4, plus a J-3 unfinished kit. The J-3 needs some work, the L-4 is complete but, needs a good cleaning, receiver, and the Super Tiger G-2300 that was...
Showing results 1 to 25 of 500



Forum Jump


All times are GMT -8. The time now is 06:51 PM.