Register

If this is your first visit, please click the Sign Up now button to begin the process of creating your account so you can begin posting on our forums! The Sign Up process will only take up about a minute of two of your time.

Search:

Type: Posts; User: A.T.

Page 1 of 40 1 2 3 4

Search: Search took 1.84 seconds.

  1. Replies
    1
    Views
    40

    Please refer to: . Hitec HPP-22 - Replacement...

    Please refer to:

    . Hitec HPP-22 - Replacement Leads, Extensions and DIY Access to Transceivers buried in models.

    ex Hitec USA Support Forum Sticky:
    Aurora 9, 9X, AFHSS 2.4Ghz Module,...
  2. Replies
    5
    Views
    258

    Rather than electronic gadgets which tend to be...

    Rather than electronic gadgets which tend to be another source of failure, for many years
    a simple power bus system works well.
    Only two power leads to receiver, all power (positive + leads) to...
  3. Replies
    3
    Views
    110

    Please refer to: . AFHSS ID-Setup (Bind) Spectra...

    Please refer to:
    . AFHSS ID-Setup (Bind) Spectra Module V3.01(0), Optima Transceiver 6, 7 & 9ch V2.02(0) & Minima Receivers
    - quick reference - latest firmware versions.

    ex Hitec USA Support...
  4. Shortcuts often end up with unexpected outcomes....

    Shortcuts often end up with unexpected outcomes.
    Always use a switch harness when connecting a battery to Receiver or Servo Interface e.g. servo programmer.
    Servo short likely when servo was...
  5. Use a separate battery, the same as when using...

    Use a separate battery, the same as when using retracts or large sail servo.
    Check the wiring diagram attached and the posts under sub section:
    "Retract Undercarriage, Flaps and payload release"...
  6. Replies
    3
    Views
    110

    Suggest an Optima in the model and a non...

    Suggest an Optima in the model and a non telemetry Minima in the dolly, refer"

    .Optima Transceiver (RX) - Dual Redundant receivers - The first turned on after the Transmitter will be the...
  7. Thread: Hitec Aurora 9

    by A.T.
    Replies
    1
    Views
    212

    Highly possible that the current draw momentarily...

    Highly possible that the current draw momentarily exceeds that which the Li-ion can deliver,
    Li-ion are not foolproof, especially if the plugs and wiring harness is inadequate.
    The following posts...
  8. Thread: FT-T6FG 6 channel

    by A.T.
    Replies
    1
    Views
    114

    1. When posting a message, it is more polite to...

    1. When posting a message, it is more polite to use standard size font, the large font is hard to read and considered to be "shouting"

    2. For best answer, suggest your request be posted under...
  9. Replies
    1
    Views
    57

    The new lead does not transfer any power, both...

    The new lead does not transfer any power, both transmitters require a fully charged battery pack.

    . Hitec Aurora 9 - Trainer / Buddy system Master & Slave function Set-up. - & Data Transfer...
  10. Replies
    3
    Views
    116

    . Hitec Warranty & Service...

    . Hitec Warranty & Service - homepage.
    Note: Hitec USA only services North/South America and Canada.
    "Hitec USA customer service department is available Monday through Friday*
    from 7am- 4:30 pm...
  11. Replies
    3
    Views
    116

    Given that you have tried a different servo on...

    Given that you have tried a different servo on that channel as well as a different receiver,
    remove the back cover and check the wiring is all intact as given age of the Transmitter,
    one wire may...
  12. Replies
    1
    Views
    93

    All Aurora, Optima transceivers, Maxima and...

    All Aurora, Optima transceivers, Maxima and Minima receivers are the same.
    However, the 2.4GHz Spectra modules do differ in output relative to countries
    as described under:

    . Spectra 2.4J Module...
  13. Answered other forum 02Jun2014...

    Answered other forum 02Jun2014
    "Not Hitec parts, suggest you refer to the instruction sheet which will most likely show those nylon washers
    to be required packers.
    Servo Grease alone will allow...
  14. Replies
    5
    Views
    237

    5

    5<20 minutes at medium speed, which represents a lot of time, is all I have bothered with.

    Best wishes

    Alan T..
  15. Replies
    5
    Views
    237

    The HS-5645MG...

    The HS-5645MG is now an older servo and no issues have been reported for a long time.
    For peace of mind, always "age" servos as electronics fail early in life or last a very long time.

    Work the...
  16. Yes Alan T. Alan's Hobby, Model & RC FAQ Web...

    Yes

    Alan T.
    Alan's Hobby, Model & RC FAQ Web Links
  17. Replies
    1
    Views
    130

    Please refer to the text and attached schematic...

    Please refer to the text and attached schematic for use with Lipo packs:

    . Batteries_Lithium Polymer - Do Not Use 3S Lipo in Transmitters

    Much more information available under sub section:...
  18. Thread: A9 flaperon issue

    by A.T.
    Replies
    3
    Views
    100

    For what ever reason your video starts then sits...

    For what ever reason your video starts then sits there with a little symbol chasing itself in a circle.
    Most programming errors are caused by inserting data in the wrong order:

    . Aurora 9 -...
  19. Whilst the RX voltage is not mentioned, the...

    Whilst the RX voltage is not mentioned, the following link will be of interest with your gear:
    . ProLine RC - History

    Agree with post #2, the most likely voltage for that receiver and servo is a...
  20. Unfortunately your 40 mhz Transmitter and...

    Unfortunately your 40 mhz Transmitter and receiver can not be changed to 75mhz without a substantial change
    to the boards - not worth the expense.
    The servos can be used with both 75 mhz and...
  21. Replies
    3
    Views
    149

    Unfortunately that servo has no on board...

    Unfortunately that servo has no on board electronics, being driven by the main board.
    If you can not repair the original ESC, then a new receiver will be required together with servo and ESC....
  22. On 72mhz your rx will be either Futaba or JR...

    On 72mhz your rx will be either Futaba or JR compatible.
    Locally, on a different frequency, Futaba crystals were being used.

    much more information available under sub section
    "Crystals,...
  23. Replies
    19
    Views
    659

    As with all mass produced items, there will...

    As with all mass produced items, there will always be the odd one sneak through for what ever reason.
    The problem with using other brand and after market brands is that whilst he housing & plug...
  24. Sticky: Aurora 9, 9X AFHSS 2.4Ghz Module, Transceivers Receivers Telemetry FAQ Setups & Tips

    Links to all FAQ, undocumented features, mixes, tips, shortcuts and more, basically anything that will help
    Hitec RCD Aurora 9, Eclipse 7 & Eclipse 7 Pro, Optic 6 & Optic 6 Sport, Optic 5, Prism...
  25. Thread: Servo Problem

    by A.T.
    Replies
    1
    Views
    208

    If all is AOK for 15 minutes from cold, then...

    If all is AOK for 15 minutes from cold, then either the ESC is overheating and shutting down or most likely going into "failsafe" because you are driving out of range or similar.
    All known ESC on...
Results 1 to 25 of 1000
Page 1 of 40 1 2 3 4
All times are GMT -6. The time now is 12:49 PM.

SEO by vBSEO 3.6.1 ©2011, Crawlability, Inc.