RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
 
Search: Posts Made By: RCPilot1726
Showing results 1 to 25 of 46
Search took 0.03 seconds.
Forum: Marketplace
01-19-2021, 06:03 PM
Replies: 1
Views: 1,155
Posted By RCPilot1726

PST reaction jet

Pst reaction jet. 78" wingspan. Pro Link pneumatic retracts, Kingtech k-100 with under 4 hours run time, mix of mks and Futaba servos. Xicoy retract and brake valves, Spektrum 12channel power safe...
Forum: RC Jets
10-17-2020, 05:07 PM
Replies: 692
Views: 294,580
Posted By RCPilot1726

Thanks, I've already tried emailing Mike @ gator...

Thanks, I've already tried emailing Mike @ gator rc and still waiting for reply. Wanting to see if their is touch up paint for the Honda/Canon theme or paint codes. While I'm here, when your throws...
Forum: RC Jets
10-12-2020, 04:23 PM
Replies: 692
Views: 294,580
Posted By RCPilot1726

Here goes... Is the cockpit available for...

Here goes... Is the cockpit available for purchase separate from ARF? Fuel tank? Not sure if mine will come with these. Thanks in advance.
Forum: RC Jets
10-12-2020, 10:18 AM
Replies: 692
Views: 294,580
Posted By RCPilot1726

Perhaps I can ask you some questions when mine...

Perhaps I can ask you some questions when mine arrives? I bought one second hand and will most likely have some questions. Looks good in pictures but I know how that goes. I've already downloaded the...
Forum: RC Jets
09-26-2020, 05:32 PM
Replies: 1,181
Views: 209,247
Posted By RCPilot1726

Thanks Paul, mine already has that lead in the...

Thanks Paul, mine already has that lead in the nose. Just put it on the Vanessa rig as suggested. Right side up, wheels down, and uat full. I cut a hatch underneath just in front on the gear. Got...
Forum: RC Jets
09-22-2020, 06:31 PM
Replies: 1,181
Views: 209,247
Posted By RCPilot1726

So installation is all done and almost ready to...

So installation is all done and almost ready to maiden. Looking back through some of these pages trying to figure out preferred balancing method. Upside down/right side up, gear retracted. Has anyone...
Forum: RC Jets
09-15-2020, 02:32 PM
Replies: 5
Views: 728
Posted By RCPilot1726

Great info guys. Thank you for the advice....

Great info guys. Thank you for the advice. Turbine should be here this weekend.
Forum: RC Jets
09-14-2020, 06:54 PM
Replies: 5
Views: 728
Posted By RCPilot1726

Fuel pump install

Hey guys, just wondering if it matters where the fuel pump is installed. Does it have to be a certain distance from the receiver & ecu? Thanks in advance
Forum: RC Jets
09-14-2020, 02:55 PM
Replies: 1,181
Views: 209,247
Posted By RCPilot1726

How far from the receiver should I mount the fuel...

How far from the receiver should I mount the fuel pump? Not sure if it matters but I thought I read that somewhere. Thanks
Forum: RC Jets
09-13-2020, 06:24 AM
Replies: 18
Views: 4,343
Posted By RCPilot1726

Glad to hear this. I think my biggest...

Glad to hear this. I think my biggest apprehension about jets was the delay in throttle response I would have to get used to. I would assume that going with the linear curve would help out with this....
Forum: RC Jets
09-13-2020, 06:20 AM
Replies: 1,181
Views: 209,247
Posted By RCPilot1726

Thanks for all the replies. I don’t necessarily...

Thanks for all the replies. I don’t necessarily plan on using the as3000 but I already have it so will try it out. Just happened to have it from before and never used it. It doesn’t seem that this...
Forum: RC Jets
09-12-2020, 09:31 PM
Replies: 18
Views: 4,343
Posted By RCPilot1726

Turbine throttle curves

Hey guys, was just reading ahead in the Kingtech manual and it talks about 3 different throttle curves when programming ECU to radio. Turbine is a Kingtech K-100G. Question is does anyone run a...
Forum: RC Jets
09-12-2020, 07:30 PM
Replies: 1,181
Views: 209,247
Posted By RCPilot1726

Have greatly enjoyed this thread. Just picked up...

Have greatly enjoyed this thread. Just picked up a yellow short nose serial # R0111. Been flying since 2007. Everything from EDF's to 1/5 and 1/4 scale warbirds. This is my first turbine, but have...
Forum: PST Jets
09-10-2020, 02:52 PM
Replies: 1
Views: 2,362
Posted By RCPilot1726

J1300r

Hey guys, recently acquired a 1300R and was wondering what exactly is needed for Xicoy upgrade. I have seen the post that shows parameters, but not sure on what is needed to buy in the first place....
Forum: Marketplace
08-30-2020, 01:25 PM
Replies: 0
Views: 1,563
Posted By RCPilot1726

Ziroli P-40

Ziroli P40, ZDZ80 for power, 24x10 Falcon carbon prop, carbon spinner, Robart pneumatic gear, Sierra giant wheels/tires, Hitec 645mg's on all except flaps. Hitec 802BB's on flaps. Add your rx and...
Forum: Marketplace
07-08-2020, 11:04 AM
Replies: 0
Views: 980
Posted By RCPilot1726

Meister Scale 1/5 P-47 Thunderbolt kit

Selling a new Meister Scale P-47 kit. This is the 1/5 scale version. Sale includes fiberglass fuse, cowl, Razorback, bellypan, supercharger doors, scale resin detail kit, Sierra gear for both mains...
Forum: Marketplace
05-12-2020, 10:26 AM
Replies: 5
Views: 1,324
Posted By RCPilot1726

How many hours on the turbine? Also, do you have...

How many hours on the turbine? Also, do you have any flight video? Thanks in advance.
Forum: Glow Engines
05-03-2020, 07:25 PM
Replies: 2,647
Views: 521,286
Posted By RCPilot1726

Thanks, just saw that.

Thanks, just saw that.
Forum: Glow Engines
05-02-2020, 05:59 PM
Replies: 2,647
Views: 521,286
Posted By RCPilot1726

Has anyone mounted the 5 cyl 180cc in a warbird?...

Has anyone mounted the 5 cyl 180cc in a warbird? I'm building a Meister Scale P-47 and this "seems" to be an option. Havent taken any measurements of my cowl just yet but wondering if anyone else...
Forum: Marketplace
11-11-2019, 09:51 AM
Replies: 1
Views: 2,655
Posted By RCPilot1726

Ziroli P-40

94" ws, ZDZ 80, 24x10 Carbon two blade prop, carbon spinner, Robart gear, Sierra giant wheels. Scale exhaust that can be made functional. Will not include receiver or batts
Forum: Kit Building
07-08-2019, 07:52 PM
Replies: 4
Views: 1,154
Posted By RCPilot1726

aa

aa
Forum: Kit Building
07-08-2019, 07:49 PM
Replies: 4
Views: 1,154
Posted By RCPilot1726

..

..
Forum: Kit Building
07-08-2019, 07:48 PM
Replies: 4
Views: 1,154
Posted By RCPilot1726

..

..
Forum: Kit Building
07-08-2019, 07:47 PM
Replies: 4
Views: 1,154
Posted By RCPilot1726

..

..
Forum: Kit Building
07-08-2019, 07:13 PM
Showing results 1 to 25 of 46
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.