jephry

Hi there,
I have just completed upgrading the ECU, is there anything i should set in the ECU?
What is the Max RPM?

Vampire

My Feedback: (2)

The "SIMJET" values are as follows:

Full Power Speed: 120,000
Idle Speed: 30,000
Start Min. Temp 100C
Max Temp : 900C
Accel delay: 40
Decel Dealy: 15
Stability Delay 050
Pump Limit: 1000
Pump start point: Auto+2
Pump Start Ramp: 006
Glow Plug Power: 35
Satrt Gas: 100%
Low Batt. Volts: 6.2vdc
Throttle Curve: FULL Expo

For all other values: us GASPAR defaults.

jephry

Hi Vampire,
Many thanks for the info.
SJ Denmark also advise me on:
Auto+3
Fuel Ramp to 004

The Flying Scot

Hi Vampire,

I am thinking about using the Gasper ecu with my simjet 2300.
Do you see any problems with this? is it possible to use the existing RPM sensor? if not can the Gasper sensor be used to pick up the existing magnets?

Best regards

Arthur

Vampire

My Feedback: (2)

Hello Arthur,

No problem using the GASPAR ECU (605 or V.10)but the old SJ-RPM board will not work. You must use the GASPAR (IXCOY) RPM board.

Best Regards,