SimJet Turbine Direct Support Direct support for SimJet Turbines provided here.

Fadec Gaspar problem

Reply
Old 06-27-2010, 09:44 AM
  #1
robson63pilot
Thread Starter
 
Join Date: Dec 2004
Location: POLAND
Posts: 31
Gallery
My Gallery
Models
My Models
Ratings
My Feedback
Default Fadec Gaspar problem

Hi
Have the problem I from my the Gaspar ECU in turbine of Simjet. ECU it informs " radio setup incorrect " or " Failsafe " [] problem stepped out alone, without reasons. So far all acted well ...Receiver it ok ,in what problem ?

Regards
Robert
robson63pilot is offline  
Reply With Quote
Old 07-01-2010, 06:54 AM
  #2
Vampire
 
Join Date: Dec 2001
Location: Bath, PA
Posts: 1,077
Gallery
My Gallery
Models
My Models
Ratings
My Feedback
Default RE: Fadec Gaspar problem

Hi Robert,

I have the following recommendations,

Reprogram the ECU to the transmitter.

Be sure that you are not "swamping" the ECU by having your Transmitter directly over or next to the ECU when operating.

Be sure that you RX is kept away from your ECU.

Be sure that you have the ECU RX cable pulged in the Rx correctly and into the Throttle channel.

Last, be sure your ECU and RX batteries are putting out the specified voltages.

Best Regards,

Vampire is offline  
Reply With Quote
Old 07-01-2010, 02:43 PM
  #3
etibedossa
 
Join Date: Dec 2003
Location: saint-maur, FRANCE, METROPOLITAN
Posts: 95
Gallery
My Gallery
Models
My Models
Ratings
My Feedback
Default RE: Fadec Gaspar problem

Also,if you have a Futaba trransmitter,you must reverse the throttle channel...
regards.
etibedossa is offline  
Reply With Quote
Old 07-05-2010, 11:12 AM
  #4
robson63pilot
Thread Starter
 
Join Date: Dec 2004
Location: POLAND
Posts: 31
Gallery
My Gallery
Models
My Models
Ratings
My Feedback
Default RE: Fadec Gaspar problem

Hi

Kery , I thank for valuable information ...

etibedossa shot in ten

Best Regards
Robert
robson63pilot is offline  
Reply With Quote
Reply


Thread Tools
Search this Thread
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off



All times are GMT -8. The time now is 06:39 PM.