Power System Sport Plus Regulator
#1
Thread Starter
Join Date: Apr 2005
Location: Southbury CT
Posts: 286
Likes: 0
Received 0 Likes
on
0 Posts
Power System Sport Plus Regulator
I have a quick question about the Power System Sport Plus and the regulator built into it. I was wondering if there was a way to adjust the regulator for power going to the servos? I hooked up a meter to it and it is reading about 5.5 volts. Is there a way to raise it or lower it? I want to try and bring it up to 5.9volts. Oris this unit not able to have the voltage adjusted?
#2
Senior Member
Join Date: Sep 2004
Location: Tempe,
AZ
Posts: 949
Likes: 0
Received 0 Likes
on
0 Posts
RE: Power System Sport Plus Regulator
Hi,
You should read 6.0V +/-0.1 at the servo outputs. What kind of meter did you use? Does your meter have a load function and were you using it?
You should read 6.0V +/-0.1 at the servo outputs. What kind of meter did you use? Does your meter have a load function and were you using it?
#3
Thread Starter
Join Date: Apr 2005
Location: Southbury CT
Posts: 286
Likes: 0
Received 0 Likes
on
0 Posts
RE: Power System Sport Plus Regulator
I just used a normal multimeter. I had a servo, and the reciever hooked up to it as well. Could Ibe doing something wrong? The multimeter does Not put a load on it though.