Mounting Smart-Fly units
I've seen where alot guys are putting wodden rails down to mount thier boards to because the white plastic piece on the bottom holds it off of the wood. Is this done on purpose to reduce vibration or some other reason?
|
RE: Mounting Smart-Fly units
Hi,
You want the unit mounted so the grommets do what they are suppose to do. This means the only point of contact on the units should be the 4 grommets. The eyelets must be installed correctly, from the bottom, and servo screws (that have a built-in washer) or regulator screws with a washer must be used so the eyelet/washer forms a "U" so that the grommet is not crushed. ORIGINAL: sparkx38 I've seen where alot guys are putting wodden rails down to mount thier boards to because the white plastic piece on the bottom holds it off of the wood. Is this done on purpose to reduce vibration or some other reason? |
All times are GMT -8. The time now is 03:53 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.