Equalizer II Flashing LED'S
Robert,
I've got a Equalizer II that i am using on my elevators. With the dials set to the run position I get a flashing green light (But not always) The elevators seem to work fine when flashing. Is this normal or do I have some sort of fault going on and if I do what would cause it to flash. If its normal whys does it do it only some of the time? I am using Hitec HS-5625 MG servos. I could not find anything in your documentation. Let me know. |
RE: Equalizer II Flashing LED'S
Hi,
You could have a fault in the selector switch. It may think its in adjust when its really in run. If you bought this from us or have the receipt and its less than 2 years old you can send it in and we will check it out and repair or replace. ORIGINAL: sparkx38 Robert, I've got a Equalizer II that i am using on my elevators. With the dials set to the run position I get a flashing green light (But not always) The elevators seem to work fine when flashing. Is this normal or do I have some sort of fault going on and if I do what would cause it to flash. If its normal whys does it do it only some of the time? I am using Hitec HS-5625 MG servos. I could not find anything in your documentation. Let me know. |
All times are GMT -8. The time now is 07:21 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.