RCU Forums

RCU Forums (https://www.rcuniverse.com/forum/)
-   Smart-Fly (Quest Engineering) Support Forum (https://www.rcuniverse.com/forum/smart-fly-quest-engineering-support-forum-328/)
-   -   Pin Switch Threads (https://www.rcuniverse.com/forum/smart-fly-quest-engineering-support-forum-328/6201424-pin-switch-threads.html)

delateurj 08-05-2007 11:16 PM

Pin Switch Threads
 
What are the threads on the pin switch? I managed to lose the nut and quick run through the HW store didn't turn up any obvious fits.

Thanks.

rrritchey 08-06-2007 09:03 AM

RE: Pin Switch Threads
 
Hi,
I cannot find any either. They are metric but I have never figured out what thread. They are very, very small. Unfortunately, as I said, I cannot find a match so I cannot stock nuts. Sorry.

delateurj 08-06-2007 12:07 PM

RE: Pin Switch Threads
 
Robert,

Thanks for the prompt reply. Its what I figured, some very fine metric thread.

No big deal, I was thinking of switching to the slide switch anyways.

Pin's neat but easily gets caught on things loading/unloading the fuse from the car when I don't think to remove at the end of the day.

- Joe.

rrritchey 08-06-2007 12:22 PM

RE: Pin Switch Threads
 
Hi Joe,
I know it does not say this but you can cut the pin off as long as you bevel the end into a cone with at least a 45 degree angle so it does not mangle the contacts inside the jack with a sharp, bunt edge.


All times are GMT -8. The time now is 03:11 PM.


Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.