nitro viper gt
06-03-2005, 02:22 PM
#26
Senior Member
Thread Starter
My Feedback: (5)
Join Date: Nov 2004
Location: Ancaster,
ON, CANADA
Posts: 431
Likes: 0
Received 0 Likes
on
0 Posts
RE: nitro viper gt
i dont got the camera workin so i cant take an y pics
ive got jus one more coat to put on it and then ill put ont eh flames.. just put on a rear custoome made roof scoop looks pretty good i made it outta stainless but im probably guna paint it the same olour of the boat
ive got jus one more coat to put on it and then ill put ont eh flames.. just put on a rear custoome made roof scoop looks pretty good i made it outta stainless but im probably guna paint it the same olour of the boat
06-05-2005, 06:50 PM
#27
Senior Member
Thread Starter
My Feedback: (5)
Join Date: Nov 2004
Location: Ancaster,
ON, CANADA
Posts: 431
Likes: 0
Received 0 Likes
on
0 Posts
RE: nitro viper gt
where did u guys put floattion on this boat there is none nowhere in my hull and im afraid i will sink it if i fun it there isnt even a way to trap air and theres not enough room to put something in it because of the closed copartments... i put a lil foam on the lid but thats all i could fittt ...???/????
12-06-2013, 06:59 PM
#28
Junior Member
Join Date: Nov 2013
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
I have the sam, Viper Nitro GT. Although, I can't get my propeller shaft to stay connected to my engine.. the black "rubber" peice would not lock the two ends together. Is there any way I can creat pressure on the point so my shaft will stay connected?
