How is this for a .12 JAP Rigger?
07-03-2009, 12:19 AM
#1
Senior Member
Thread Starter
Join Date: Jul 2005
Location: Center City,
MN
Posts: 711
Likes: 0
Received 0 Likes
on
0 Posts
How is this for a .12 JAP Rigger?
My lil .12 JAP rigger has loosened up and ..... 
There are still several things needing tweaking (for example, see how the water comes off the boat in the turns and in the front stretch... it is pulling to the right... I'm fighting it in the front stretch... and just letting her arc in the back stretch).
Edited for language
There are still several things needing tweaking (for example, see how the water comes off the boat in the turns and in the front stretch... it is pulling to the right... I'm fighting it in the front stretch... and just letting her arc in the back stretch).
Edited for language
07-03-2009, 04:05 PM
#3
RE: How is this for a .12 JAP Rigger?
Looking good Todd! I've got the plans downloaded and am trying to see if my sister can laser cut them. I'm only going to get a couple of kits cut for my own use only as I'm liable to mess one up!
I've already got just about everything else I need already sitting here.
I've already got just about everything else I need already sitting here.
