Park Zone Wildcat stabilizer came off inflight!
05-08-2012, 07:06 PM
#1
Senior Member
Thread Starter
Join Date: Jul 2004
Location: Kenedy,
TX
Posts: 116
Likes: 0
Received 0 Likes
on
0 Posts
Park Zone Wildcat stabilizer came off inflight!
I love the PZ foamies, but the right half of my wildcat's stab came off while at the top of a loop this evening. I landed OK, 
and found the piece.
My queston is this:What type of glue should I use to reattach the stab with? I was worried during assembly about the pressure fit of the stab parts and shure enough, they don't stay put!
Any help? My email is [email protected] since I don't visit RC univ. much.
Thanks
Philip
and found the piece. My queston is this:What type of glue should I use to reattach the stab with? I was worried during assembly about the pressure fit of the stab parts and shure enough, they don't stay put!
Any help? My email is [email protected] since I don't visit RC univ. much.
Thanks
Philip
05-13-2012, 05:59 AM
#2
My Feedback: (3)
Join Date: Jul 2003
Location: Floresville,
TX
Posts: 94
Likes: 0
Received 0 Likes
on
0 Posts
RE: Park Zone Wildcat stabilizer came off inflight!
I have the PZ 300 extra i have used epoxy but i would alos use some round toothpicks to help renforse it, test fit them in place and epoxy them as well the repair should be fine!
