Crankshaft Thrust washer for ST-2500
#1
Banned
Thread Starter
My Feedback: (1)
Join Date: Jun 2002
Location: Brisbane, Queensland, AUSTRALIA
Posts: 7,744
Likes: 0
Received 2 Likes
on
2 Posts
Crankshaft Thrust washer for ST-2500
Folks,
I have an old ST-2500 glow engine that I rebuilt a few years back.
I recently swapped props and upon tightening the prop I noticed I could no longer turn the engine over. I suspected front bearing had collapsed but upon pulling the engine down found it was the thrust washer behind the front bearing that had failed and was in several pieces.
Photos attached.
I'm trying to get hold of the part 22222006 but unable to locate any. Are you able to assist?
Regards
Peter
I have an old ST-2500 glow engine that I rebuilt a few years back.
I recently swapped props and upon tightening the prop I noticed I could no longer turn the engine over. I suspected front bearing had collapsed but upon pulling the engine down found it was the thrust washer behind the front bearing that had failed and was in several pieces.
Photos attached.
I'm trying to get hold of the part 22222006 but unable to locate any. Are you able to assist?
Regards
Peter
#4
My Feedback: (11)
OK, we see what part you need. The one that's aft of the front bearing, not in front of it. We'd have zero parts at this time, and while we're expecting to be getting things by the end of the year, that one won't be coming because its engine series is long discontinued.
Last edited by Bax; 07-08-2015 at 05:43 AM.
#5
Banned
Thread Starter
My Feedback: (1)
Join Date: Jun 2002
Location: Brisbane, Queensland, AUSTRALIA
Posts: 7,744
Likes: 0
Received 2 Likes
on
2 Posts
that is a bugger.
Thank goodness for fleabay I managed to get a complete new in pack crankshaft with the washer for $55.95 USD including post to Australia.
Expensive little washer!
Thank goodness for fleabay I managed to get a complete new in pack crankshaft with the washer for $55.95 USD including post to Australia.
Expensive little washer!
Last edited by Peter_OZ; 07-07-2015 at 09:01 PM.