HK 600 question
#1
Senior Member
Thread Starter
My Feedback: (5)
Join Date: Feb 2008
Location: Pagosa Springs, CO
Posts: 158
Likes: 0
Received 0 Likes
on
0 Posts
HK 600 question
I acquired 600 with no speed controller or batteries. Since funds are an object I was thinking about finding a used Align speed controller and I'm finding some decent prices on 22.2 v 3500mah batteries. Can anyone give me info as to if these battereis will work and is Align a good ESC and which size do I want. Thanks for the help.
#2
Junior Member
Join Date: Sep 2010
Location: Casa Grande,
AZ
Posts: 7
Likes: 0
Received 0 Likes
on
0 Posts
RE: HK 600 question
Iuse HobbyWing Platinum. The cost is low(er) and after using 8 of them on my fleet with no failures, recommend them.
I would go at least 80 amp for the 600...and even up to 100 amp for hard 3D and FBL.
I would go at least 80 amp for the 600...and even up to 100 amp for hard 3D and FBL.
#3
Senior Member
Join Date: Aug 2004
Location: richmond, CA
Posts: 629
Likes: 0
Received 0 Likes
on
0 Posts
RE: HK 600 question
check out HK hobby, they have some descent lipo batt. I may consider going to 5000 mah instead of 3500mah.
I have also the hk600 and I used 2 3000mah 6s for forward flite (5 min each flite) 2 batt. just to balance its center gravity. also
I used 2200mah 3s to power the HK esc opto 80 amp + regulator to power the reciever.
I have also the hk600 and I used 2 3000mah 6s for forward flite (5 min each flite) 2 batt. just to balance its center gravity. also
I used 2200mah 3s to power the HK esc opto 80 amp + regulator to power the reciever.