Mini MGT 3.0 - Wasp .26 conversion
12-29-2010, 04:35 PM
#1
Junior Member
Thread Starter
Join Date: Dec 2010
Location: madison, SD
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
Mini MGT 3.0 - Wasp .26 conversion
Hey, everyone im new to the forum here just like to say hi!
I have a mini mgt 3.0 and just put one tank of gas through the motor when i scored a great deal on a brand new Wasp .26
so my question is, what will i need for this conversion? I'm assuming it wont drop right in and i will need additional parts, bearings ext.
i have done multiple searches for info on this conversion and couldn't really find much.
Any help or info would be gratefully appreciated!
I have a mini mgt 3.0 and just put one tank of gas through the motor when i scored a great deal on a brand new Wasp .26
so my question is, what will i need for this conversion? I'm assuming it wont drop right in and i will need additional parts, bearings ext.
i have done multiple searches for info on this conversion and couldn't really find much.
Any help or info would be gratefully appreciated!
12-29-2010, 06:48 PM
#3
Junior Member
Thread Starter
Join Date: Dec 2010
Location: madison, SD
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
RE: Mini MGT 3.0 - Wasp .26 conversion
ORIGINAL: mrsheldon
Check out the new era kit I would also get an integy revo 3.3 (3shoe)clutch.
Check out the new era kit I would also get an integy revo 3.3 (3shoe)clutch.
also, anyone know of a good exhaust to run with the wasp .26?
