YS-160DZ
05-11-2005, 09:45 AM
#1
Thread Starter
My Feedback: (7)
Join Date: Oct 2003
Location: Navarre,
FL
Posts: 601
Likes: 0
Received 0 Likes
on
0 Posts
YS-160DZ
Hey Don,
I read your start up procedures on the 140DZ on Tony Stillman's website. Did you do the same procedure on the 160? Is there anything differently you did?
Thanks
Greg Grigsby
I read your start up procedures on the 140DZ on Tony Stillman's website. Did you do the same procedure on the 160? Is there anything differently you did?
Thanks
Greg Grigsby
05-12-2005, 10:01 PM
#2
RE: YS-160DZ
Same procedure. The key to the technique I use is not running it up and trying to adjust it there, but short bursts of full throttle, separated by turning in the needle by 1/8 turns and listening for the tell tale knocking metalic sound at full throttle burst, then backing off about 1/4 turn.
