H9 Ultimate
#1
Senior Member
Thread Starter
My Feedback: (1)
Join Date: Jun 2003
Location: Boca Raton,
FL
Posts: 133
Likes: 0
Received 0 Likes
on
0 Posts
H9 Ultimate
Mike:
I recently acquired a H9 Ultimate from a good builder and have a question. The balance is right on the mark but when flying the trim required on the elevators is 1/4 inch down to fly level. Could this mean the incidence on one or the other wing be out? What is the spec for upper & lower wing incidences?
Thank you for your time.
ifshnee
I recently acquired a H9 Ultimate from a good builder and have a question. The balance is right on the mark but when flying the trim required on the elevators is 1/4 inch down to fly level. Could this mean the incidence on one or the other wing be out? What is the spec for upper & lower wing incidences?
Thank you for your time.
ifshnee
#4
Senior Member
My Feedback: (12)
Join Date: Sep 2002
Location: bonney lake,
WA
Posts: 470
Likes: 0
Received 0 Likes
on
0 Posts
RE: H9 Ultimate
Depends on where your CG is 'right' at? Bottom wing should be 0, top -1/2 deg as i recall. the stab should be 0 deg as well. what does the bird do when pulling to a 45 deg climb? thrust line could be off as well.