Futaba 401 gyro
#1
Junior Member
Thread Starter
Join Date: Sep 2012
Location: Guymon, OK
Posts: 10
Likes: 0
Received 0 Likes
on
0 Posts
Futaba 401 gyro
My Raptor crashed and after I got it back together everything runs well, but my futaba 401 acts like it is in heading hold but the red LED doesn't blink to show it is in heading hold. Nothing has changed on my setup as far as the gain and sensitivity. Should I send to futaba for repair or just get a new one?
#3
Junior Member
Thread Starter
Join Date: Sep 2012
Location: Guymon, OK
Posts: 10
Likes: 0
Received 0 Likes
on
0 Posts
RE: Futaba 401 gyro
My bad. Got confused on the light, but when I was hovering it had a tail twich going on and I'm not real sure what was going on with that.
#5
Junior Member
Thread Starter
Join Date: Sep 2012
Location: Guymon, OK
Posts: 10
Likes: 0
Received 0 Likes
on
0 Posts
RE: Futaba 401 gyro
Everything went well for three flights untill I landed the last time. When I killed the motor the tail stopped and made a sound like a bad bearing. I have replaced all the bearings on the head and starter shafts. I'm thinking it maybe the oneway in the centrifical clutch. Any thoughts?