rebuilder

Dark............any news on this one??

darksideofasaucerfulofsecrets

No yet BUILDER, this project is sitting on the shelf, I am trying to figure out a way to create a second pivot point on the front axle so I can lean the front axle side to side as well as up and down.  This should enable me to 3-wheel like I want with one of the front wheels up off the ground... I will post a pic or two of the idea so far, just a little plain paint drawing but it gets the idea across.  Will post later if I remember

jaken0313

heres some vids i found on youtube a while back. may not be applicable to your application, but maybe more for inspiration.

http://www.youtube.com/watch?v=ji-z3...eature=related

http://www.youtube.com/watch?v=eQYnx...eature=related

http://www.youtube.com/watch?v=j_uCz...eature=related

hope to see the snoop deville's progress soon!!

texx

jaken0313
Nice find .. [sm=thumbup.gif]
These videos are very explicit ..
This will help DARK for his project ...
THANK ..

darksideofasaucerfulofsecrets

Yes, this is the general function and idea that I am shooting for with the snoop deville, but I can't figure out how to apply this to my toy grade axles that have no pivot points.   The stock hydraulics ange the entire front and rear axles up and down, but I still have not figured out an idea for getting a pivot point side to side.  Have had a few ideas but nothing has passed the "drawing board". 

Wolfangel

I might be able to help you with your SNOOP-DEVILLE.......hehe. I have built a number of hydraulic cars and trucks. I am currently using a 7 channel radio, but i have used a 6 channel radio.....and if you get one off e-bay......the price isnt that bad. I found my 6 channel for $50.

To see some of my work......go to YOUTUBE.......then type in WOLFANGEL37.......it will bring up some of my videos of a car and 2 trucks i have done.

E-mail me if you want anymore info.