MIP THREAD!!!!!
03-24-2012, 04:38 PM
#1
Junior Member
Thread Starter
Join Date: Mar 2012
Location: Cypress , CA
Posts: 7
Likes: 0
Received 0 Likes
on
0 Posts
MIP THREAD!!!!!
Hi guys, this is Matt over at Morre's Ideal Products better known as MIP. I would like to start a new MIP based thread so I can get some feedback about our products. The good, the bad, and everything in-between, bring it all on
! I'm the customer service/ tech guy/ team manager over here so if you have any questions, or need help, make sure to hit me up.
We also have a couple new products in the works, the first of which is our Realshocks Bypass 1 product. Check out Velocity RC Magazine's vid for a detailed overview with Eustace Moore (MIP Owner).
visit vrcmag.com for the vid
Enjoy!
Regards,
Matt
Customer Service/Tech Support/Team Manager
! I'm the customer service/ tech guy/ team manager over here so if you have any questions, or need help, make sure to hit me up.We also have a couple new products in the works, the first of which is our Realshocks Bypass 1 product. Check out Velocity RC Magazine's vid for a detailed overview with Eustace Moore (MIP Owner).
visit vrcmag.com for the vid
Enjoy!
Regards,
Matt
Customer Service/Tech Support/Team Manager
04-06-2012, 10:19 PM
#3
Senior Member
Join Date: Apr 2007
Location: Grand Rapids,
MI
Posts: 121
Likes: 0
Received 0 Likes
on
0 Posts
RE: MIP THREAD!!!!!
Need to toughen up the Summit drive shafts. I want to buy some but have not due to reading that they break as easily as the stock shafts. I do remember having them on my T-4 a few years ago, I broke a couple then too. The "bell" shaped part at the end of the shaft breaks. What is your replacement policy these days?
