Lipo problem!!! help need advice
 

I have just up graded to lipos and i switched my castle sct esc to the lipos setting...and this is were i think my problem is i dont think i have it set up wright .i didnt know were to set the LVc setting for the lipos..so i setit to auto-lipo and the truck runs but acts like theres no ass behind it so please help me if you have any advice

the lipos are gen ace 5000mAh 2s 40c an 50c

RE: Lipo problem!!! help need advice
 

Sounds like its in training mode. Read the manual and see how to set it to race mode. Thats where i would start. Lvc should be set to 3.4....some1 correct me if im wrong.

RE: Lipo problem!!! help need advice
 

i dont believe the sct esc has traning mode?

RE: Lipo problem!!! help need advice
 

If you tried setting the LVC through the transmitter instead of Castle Link you may have inadvertently changed a different setting. Maybe turned down punch or something. Unless you went from a 8 or 9 cell NiMh, a 2s Lipo shouldn't have decreased performance. The LVC should be set between 3.2-3.4volts per cell to make sure the pack doesn't go below 3.0 volts per cell during use. Plug the Castle Link into your pc, use the Restore Defaults button, then set the LVC to auto or between 3.2-3.4 volts per cell. Sounds stupid but, you know Lipos don't come fully charged right? And Castle esc's don't have a training mode. If that all checks out, might want to make sure endpoints, trim or something else didn't change on radio either and maybe recalibrate.