Display error of voltage values in GigaControl 2.63?
01-01-2014, 12:33 PM
#1
Thread Starter
Join Date: Nov 2004
Location: Skelleftea, Vasterbotten, SWEDEN
Posts: 40
Likes: 0
Received 0 Likes
on
0 Posts
Display error of voltage values in GigaControl 2.63?
Why are the values so wrong in GigaControl v2.63 for voltage on both the transmitter and receiver?
Software in tx and rx is v2.63.
The errors is 0.2 V at idle and 0.1 V-0, 15V at load of servos.
/Ville
Software in tx and rx is v2.63.
The errors is 0.2 V at idle and 0.1 V-0, 15V at load of servos.
/Ville
