New 35% Extra 300
02-09-2008, 03:38 PM
#128
Senior Member
Join Date: May 2002
Location: Flower Mound (near Dallas),
TX
Posts: 6,189
Likes: 0
Received 2 Likes
on
2 Posts
RE: New 35% Extra 300
I looked around and I don't really have any decent photos with the DA-100. I'm working on a Giles right now with teh DA-100 and it will be pretty much the same, I will get some pics when I can.
I noticed the AR9100 also, I have one in my Extra too, works nice.
TF
I noticed the AR9100 also, I have one in my Extra too, works nice.
TF
02-09-2008, 03:56 PM
#129
Senior Member
My Feedback: (15)
Join Date: Feb 2002
Location: Goldsboro,
NC
Posts: 1,960
Likes: 0
Received 0 Likes
on
0 Posts
RE: New 35% Extra 300
yep, swapped out the AR9000 I was using, both work great but I figured the 9100 works better with the A123s and Im a sucker for new toys.
I like cans but cant stand the weight.
The way its baffled and cutout you can touch it after a 10 minute 3d session, runs real cool.
You can reach the carb choke lever with your finger thru the muffler cutout.
Motor is mounted on a plyplate with short standoffs.
I like cans but cant stand the weight.
The way its baffled and cutout you can touch it after a 10 minute 3d session, runs real cool.
You can reach the carb choke lever with your finger thru the muffler cutout.
Motor is mounted on a plyplate with short standoffs.
02-09-2008, 05:04 PM
#130
Senior Member
My Feedback: (16)
Join Date: Sep 2004
Location: Suffolk,
VA
Posts: 653
Likes: 0
Received 0 Likes
on
0 Posts
RE: New 35% Extra 300
yeah ups is saying my 9100 will be here monday 
i just got my JR X9303 today fedex delivers on saturday who knew should have everything else shortly thereafter just getting all the little stuff out of the way until then
i just got my JR X9303 today fedex delivers on saturday who knew should have everything else shortly thereafter just getting all the little stuff out of the way until then
08-14-2008, 08:49 PM
#131
My Feedback: (2)
Join Date: Nov 2004
Location: vero beach,
FL
Posts: 60
Likes: 0
Received 0 Likes
on
0 Posts
RE: New 35% Extra 300
I have installed cans, using the plywood mounts provide by Tom. After running 5 gallons all seem well, but I am concerned about the lack of air flow along the length of the cans. The mounts block airflow about half way. There are six 2"x3" openings below the cannisters where I have removed the ultracoat. The air can flow into the cowl and out the front 2 openings but there is not good air circulation behind the mounts.
How have other people address this problem.
How have other people address this problem.
