dz160 stop in Loud noise
#1
Thread Starter
Join Date: Feb 2007
Location: RESHON LEZIYYON, ISRAEL
Posts: 109
Likes: 0
Received 0 Likes
on
0 Posts
dz160 stop in Loud noise
Hello
my engine dz160
Event that happened to me today
I tried to find the peak position ( max rpm ) by adjusting the HS needle valve
i close the needle more and more And suddenly the engine stop in Loud noise and the prop nut Released.
this happened when the HS needle approximately 0.5 turns open from fully closed.
1. Why did it happen and if I caused damage to the engine ? ( Then I could run the engine again )
2. How do you recommend me to find the max rpm ?
Thanks
kobi
my engine dz160
Event that happened to me today
I tried to find the peak position ( max rpm ) by adjusting the HS needle valve
i close the needle more and more And suddenly the engine stop in Loud noise and the prop nut Released.
this happened when the HS needle approximately 0.5 turns open from fully closed.
1. Why did it happen and if I caused damage to the engine ? ( Then I could run the engine again )
2. How do you recommend me to find the max rpm ?
Thanks
kobi
#3
Senior Member
Join Date: Aug 2004
Location: MilduraVictoria, AUSTRALIA
Posts: 157
Likes: 0
Received 0 Likes
on
0 Posts
RE: dz160 stop in Loud noise
As Petec states, you may have done damage, bent valves are the most common, you may have put half moon circles on top of the piston as well.
The circles on top of the piston are ok, but check the valve stems for straightness. But also be aware that piston damage etc is also possable,
strip it down and inspect.
I don't know what Petec and others do in the US, but I prefere the pinch method of determining the max rpm of the 160, there should be a previous thread somewhere
about this method.
YS Servive Down Under
#5
Thread Starter
Join Date: Feb 2007
Location: RESHON LEZIYYON, ISRAEL
Posts: 109
Likes: 0
Received 0 Likes
on
0 Posts
RE: dz160 stop in Loud noise
Thank you for answers
If it's very disappointing because of a momentary mistake like lean the engine
Can be caused damage to the engine,
What, who designed the engine did not think that an error can happen ?
If it's very disappointing because of a momentary mistake like lean the engine
Can be caused damage to the engine,
What, who designed the engine did not think that an error can happen ?