YS 110S regulator tear down
10-09-2013, 02:49 AM
#2
Thread Starter
Join Date: Dec 2007
Location: HobartTasmania, AUSTRALIA
Posts: 16
Received 0 Likes
on
0 Posts
OK, it's pressed together.
Based on info from Richard Verano I put some fairly hard urethane tubing on the adjacent nipples of the upper and lower sections and pushed a lubed screwdriver blade between them - hard at first then suddenly pops - watch out for flying parts.
Press back together with drill press or whatever using suitable packing pieces.
Based on info from Richard Verano I put some fairly hard urethane tubing on the adjacent nipples of the upper and lower sections and pushed a lubed screwdriver blade between them - hard at first then suddenly pops - watch out for flying parts.
Press back together with drill press or whatever using suitable packing pieces.
