91 FZ needle settings
#1
Senior Member
Thread Starter
Join Date: Dec 2002
Location: SOUTH,
TX
Posts: 712
Likes: 0
Received 0 Likes
on
0 Posts
91 FZ needle settings
Dave, I cant find my manual and ran my engine as it came back from repair at YS, but I cant get it to idle down, it stays high, around 3000 and then dies as I close the throttle.
Can you tell me what high and low needle settings should be as a rough start point.
Thanks
Joey
Can you tell me what high and low needle settings should be as a rough start point.
Thanks
Joey
#2
Senior Member
RE: 91 FZ needle settings
Go to the website and follow the instructions www.ysperformance.com
I suspect the regulator and idle are both too lean.
I suspect the regulator and idle are both too lean.
#3
Senior Member
Thread Starter
Join Date: Dec 2002
Location: SOUTH,
TX
Posts: 712
Likes: 0
Received 0 Likes
on
0 Posts
RE: 91 FZ needle settings
Dave, I just pulled the valve cover off, And there is NO tappet clearance at any time of the cycle. I now suspect that this has been the problem all along. My question is that it came from YS service department like this, should it have come back to me in this condition? I feel terrible about trying to run the engine like this, but I didnt think to check the tappet clearance and just expected it to run when I got it back.
Please help,
Joey M
Please help,
Joey M
#5
Senior Member
Thread Starter
Join Date: Dec 2002
Location: SOUTH,
TX
Posts: 712
Likes: 0
Received 0 Likes
on
0 Posts
RE: 91 FZ needle settings
I will try to call, but I cant get anyone to answer, I will try again, I guess Ill send it back in.
I dont want to complain to the guys, I just want the engine to work.
Thanks Dave.
Joey
I dont want to complain to the guys, I just want the engine to work.
Thanks Dave.
Joey