Drill Jig Problem
#1
Thread Starter
My Feedback: (21)
Drill Jig Problem
I just received the drill jig I orderd, and it seems the holes don't line up with the front hub. It lines up closest with the inner set of holes but is off a little bit. These sets of holes are too small for the bolts also. My engine is a ZDZ 120.
#2
Senior Member
Join Date: Jul 2002
Location: MD
Posts: 515
Likes: 0
Received 0 Likes
on
0 Posts
RE: Drill Jig Problem
ZDZ has matched to hub bolt spacing of 3W and DA, which is 34mm for over 2 years now. If you have an older ZDZ 120 or 160, the bolt spacing will be 31mm.