zdz 80 blue head starting problem
#1
Member
Thread Starter
Join Date: Jan 2007
Location: conroe, TX
Posts: 61
Likes: 0
Received 0 Likes
on
0 Posts
zdz 80 blue head starting problem
I am having problems starting the zdz 80 blue head. It use to start after a couple of flips, and I have tryed the 5 & 5. Now I have to start it with a starter, it runs great after you get it started. After it is warmed up it will flip start but cold you can flip it 50 times. Whats the problem? I don't want to buy a starter? thanks
#2
Senior Member
Join Date: Jul 2002
Location: MD
Posts: 515
Likes: 0
Received 0 Likes
on
0 Posts
RE: zdz 80 blue head starting problem
Be sure the low end is not too lean. Set it to 2 turns out. Give it a try.
Be sure the throttle butterfly is opening in the correct direction.
The screw head should face IN toward the engine when closed.
Be sure the throttle butterfly is opening in the correct direction.
The screw head should face IN toward the engine when closed.
#3
Member
Thread Starter
Join Date: Jan 2007
Location: conroe, TX
Posts: 61
Likes: 0
Received 0 Likes
on
0 Posts
RE: zdz 80 blue head starting problem
I did not get the instructions with my motor, it was already tuned. which screw is which? Or where can I find the instructions to this carb?
Thanks Robert
Thanks Robert
#4
Join Date: Jan 2006
Location: Kalona,
IA
Posts: 2,517
Likes: 0
Received 0 Likes
on
0 Posts
RE: zdz 80 blue head starting problem
Robert, The needles are marked 'H' and 'L' for reference....High and Low speed needles, respectively.
Here is a link to the ZDZ engine manual: http://www.zdz-modelmotor.cz/zdz/en/dfu.asp?id=1
Sorry Mike, not trying to intrude here...just help out if I can.
Chad
Here is a link to the ZDZ engine manual: http://www.zdz-modelmotor.cz/zdz/en/dfu.asp?id=1
Sorry Mike, not trying to intrude here...just help out if I can.
Chad