ZDZ 120 B2RV
11-06-2009, 09:06 PM
#1
Thread Starter
My Feedback: (26)
Join Date: Apr 2003
Location: BurekupWestern Australia, AUSTRALIA
Posts: 9
Likes: 0
Received 0 Likes
on
0 Posts
ZDZ 120 B2RV
I purchased these mufflers from AMT but have a issue with the installiation now. I have had several 50-80cc singles in the past however my first twin. The muffler off set is approx 33mm, now to mount the engine i would need to place spacers on the mounts to move the engine forward and then need to hack the cowl, not what i really wanted to do.
I have been told that the off set is typical of twins, when running mufflers like these, Is this correct ? A few guys at my field run other twins however have not got the same issue,
Not sure what direction to go in....
Dave
I have been told that the off set is typical of twins, when running mufflers like these, Is this correct ? A few guys at my field run other twins however have not got the same issue,
Not sure what direction to go in....
Dave
11-08-2009, 08:26 AM
#3
Thread Starter
My Feedback: (26)
Join Date: Apr 2003
Location: BurekupWestern Australia, AUSTRALIA
Posts: 9
Likes: 0
Received 0 Likes
on
0 Posts
RE: ZDZ 120 B2RV
Yes, already tried that, However the exhaust outlets are angled back about 80degrees so turning the exhausts around will have them facing forward........
