Notice: This version of the RCU Marketplace is no longer accepting new listings.
We have a brand new, easy to use RCU Marketplace
Come take a look. On April 5, 2018, once all existing listings have expired, the old marketplace will close for good. In the meantime, feel free to browse what is for sale here, but please make any new for-sale or trade listing in the new Marketplace!
Old school helicopter parts pn = part number dimensions approx. I used a ruler 2mm threaded rod, 44mm long pn 528 one sealed bearing pn 363 dimensions 15mm OD, 5mm ID, 4mm thick (2) bearings pn S0352 bearing same dimensions as pn 363 but not sealed small plastic part, possible tail rotor part pn 1566 (4) 3mm pin for E clip, total length 17mm pn 1567 (6) 2mm threaded rod 10mm long pn 3510 (4) looks like needle bearing 2mm X 9mm pn 246 rod/shaft 5mm X 43.5mm long 3mm hole one end, 1mm hole in other end pn580 one threaded rod 2mm X 75mm pn 3511 small brass bushing or pulley 6mm OD 2 mm OD 4mm wide with machined section smaller inside dia. pn 370 (2) "C" clips 10 in package 2mm inside dia. pn 355 (2) rubber "O" ring OD 12mm ID 7mm, 2mm thick pn 3506 oddball bag of parts used: 4 tail rotor blade ends with bearing, tail rotor gears one set looks like 2mm set screws quantity 9 one large possible main shaft bearing OD 19mm X ID 6mm 5mm thick possible main rotor blade balancing rig second oddball bag of parts unknown next is Schluter robbe parts: (3) one threaded rod 2mm X 75mm pn S3511 looks like a needle bearing 1.5mm X 7mm long pn S0285 (2) hex head bolt 3mm X 26mm long, shank and threads only pn S1555 looks like ball links would go on each end to connect something together most likely for main rotor head pn S0396 tail rotor blade end 3 pieces pn S0280 unknown part looks like it hold another part down, similar to a cap for holding a connecting rod to the crankshaft of an engine pn S0283 bell crank, one hole on the short side, three holes on the long end, with gusset between, plastic possible tail rotor compensation pn S0384