Will sell engine for $160 with out the conversion kit, If selling them separately would like to sell engine first before selling conversion kit in case I keep the engine.
This is a G62 used good condition strong compression runs solid that was installed on a 3rd scale Pup and had a little over 1 season of use before garaged 4 plus years with plane, engine was ran before I picked up plane.
It currently has magneto set up with spring starter installed but I am also selling it with a new rc extreme power plug and play ignition conversion kit . It also has a benett exhaust with extended stingers to route exhaust to center over the head.
It is a pretty clean engine and would look it if not for the discoloring on the head, prop hub and other areas which is some kind of over spray of anti corrosive prep and paint, doesn't effect quality of engine. 225 shipped to anywhere lower 48.
From RC extremes web site : Zenoah ignition conversion kits are a plug and play system. No timing and easy installation. Kits come with full instructions
Stock Specifications: (These are manufacturer specs and may not necessarily reflect the specs of the item for sale)
3.800 cu. in.
- 1 cylinder - Displacement: 3.800 cubic inches - Bore: 1.900 (in.) - Stroke In: 1.400 (in.) - Shaft: 10 x 1.25mm thread - Low RPM: 2000 - High RPM: 10000 - 4.750 bhp - Weight (no muffler): 73.00 oz.
- Giant - Racing - Pattern/Aerobatics - Scale - Sport