This JetCat P-60SE Turbine Engine has just over 4.5 hours run time on it. I've had it in a Boomerang Nano for about a year and it starts and runs great - every time. Serial number is 6697. A new FOD screen is included and all accessories are included. This turbine retails for $2025.00
Shipping is FREE.
JetCat P60-SE Special Edition Turbine complete with starter includes: The new design of the P60-SE incorporates an optimized compressor/diffusor-system, resulting in higher engine performance and reliability. The engine follows throttle commands almost without delay. The P-60 is capable of kerostart with external kero plug, not included.
Includes: Jet-tronic ECU (fuel control electronics) GSU (Display and Programmer) LED I/O board Miniature fuel pump Electronic starting gas valve Electronic Fuel valve Fuel & Gas tubing connector set, fuel filter, and complete cable set Starting gas tank Turbine mounting clamp, RamTec compatible
Specs: Thrust: 13 LB @ 165,000 RPM Weight: 1.87 LB, incl. starter Diameter: 3.25 inches RPM Range: 50,000 - 165,000 Exhaust gas temp.: 580°C -690°C Fuel consumption: 8 oz per/min at full power Fuel: Jet A1, 1-K kerosene Lubrication: approximately 5% synthetic turbine oil in the fuel Maintenance interval: 25 hours