This started life as a TF GS ARF Corsair that had one flight on it. Landing gear blocks were damaged from a hard landing. When I got it , I stripped the monocote off, rebuilt new scale rudder and scale elevators with trim tabs and scale outline and ribs. These are now fabric covered. Rebuilt the landing gear area with real plywood ribs and oak landing gear rails. All new sheeting applied. I discarded the stock cowl and bought a Fiberglass Specialties cowl with open cowl flaps and scale engine. Plane has a full cockpit with full body pilot , Robart #148 retracts air operated with operating gear doors, scale Hanger 9 Tail wheel. DLE 55 RA engine with all Hitec 645 analog bb mg servos. Has Futaba standard servos for throttle, gear valve and choke.These are used everything else was bought new for the plane. Engine has a few minute run on it to check the needles. Paint work and panel and rivet detail was done by Carl Stewart. Has some panel and rivet detail not completely done. Has droppable fuel tanks.
This is RTF, just bind to your transmitter if it's Spectrum. Has a 7 channel Spectrum receiver with one satellite, two 2000 ma NIHMD battery packs, one for RX one for ignition.
$1800 buyer pays crating and shipping
Will Trade Only trade I'm interested in is a Byron Hellcat, Ziroli Hellcat or Jerry Bates Hellcat RTF