CNC Machined-Laser cut build & balance stands. Made one of these for my own personal use and liked it so much decided to build a few more. These have high quality non marking polyurethane casters, 1/2 thick EPDM rubber pads & velcro safety straps are pre installed. Steel gusset plates for strength. Will raise and lower from 20 to 42 so you can sit comfortably in a chair and work on your bird. Or raise it up to get at your gear etc. without flipping your plane over. The best part is you can safely balance your plane when finished. The stand with the 47 balance bar was tested and will handle the biggest jets out there and 40% planes without any problem at all. Roll them around with one hand. The stand will also tilt in 10,20 & 30 degree increments both ways. Just pull the pin and rotate it where you need it. Same pin to balance. No complicated measuring involved just set your planes CG on the removable pointed boss and pull the pin to check your CG. Parts & different style cradle plates are available.
The 47 balance bar model comes with 20 long x 4 wide plates. The 30 balance bar model comes with 10 long x 4 wide plates.
MADE IN THE USA. Built to last. Any questions please ask.
Stand w/ 47 balance bar-(2 top pics)- 420.00 total shipped to your door. (PayPal fee included) Stand w/ 30 balance bar -(2 lower pics) 350.00 total shipped to your door. (PayPal fee Included)