Notice: This version of the RCU Marketplace is no longer accepting new listings.
We have a brand new, easy to use RCU Marketplace
Come take a look. On April 5, 2018, once all existing listings have expired, the old marketplace will close for good. In the meantime, feel free to browse what is for sale here, but please make any new for-sale or trade listing in the new Marketplace!
I assembled this Escapade MX 30 last month with the intention of flying it. I don't see that happening any time soon so I decided to sell it. Just have way too many airplanes to fly them all. If you tell my wife that I said that, I'll swear you're lying!
It has a DLE 30 for power. I put one of those simple mufflers on the end of the exhaust pipe. They're supposed to take the bark out. It will come off easily if you like the bark. Receiver is a Spektrum AR6600T 6 channel DSMX telemetry receiver. Servos on ailerons, elevators, rudder, and flaps are Futaba S3010 high torque servos. Throttle uses a Futaba S3004 servo. Choke is manual with a bellcrank linkage so you can choke from the side of the fuselage with canopy in place. There is a dual switch with fuel dot mounted on the fuselage side. One switch for radio gear, the other for ignition. It has an Rcexl Opto kill switch with LED. LED is mounted through side of fuselage. Battery packs for radio gear and ignition are 6.6 volt 1800 mAh LIFE packs. I installed a voltage regulator on radio gear.
Everything was purchased new for this airplane. It has never been run or fueled up. I have the manuals for the plane, engine, and receiver.