This is an all cf HOR 45x13.25" mono with all the hardware needed to get the it in the water EXCEPT mounts and engine. Includes a 4x24x1/8" sheet of beautiful cf to make rails with. This cost me $50 separate from the boat. I did not like the rails that came with it. I will cut it into 2x2" wide pieces for u. This allows u to pre drill for mounts, tbar, and gas bag or tank mount. I will include cf cloth and epoxy to install them too.
The hull is VERY light and Very rigid. NO need to cover the bottom with cloth unless u want a wow factor. This is NOT a shoe box joined hull rather the clean seam type with cf cloth and epoxy reinforced seam on the inside that runs the full length and width of the hull
All hardware needed is included: 2water pickup rudder, stinger already installed and offset for torque steer(light hulls like this with large engines will torque steer. I have been building boats for 36 yrs and trust me it will happen with light hulls lke this), 2 sets of trim tabs, a turn fin(not in pics), radio box with a complete kit for installing waterproof push rods, 2nib GERMAN Multiplex servos for steering and throttle, that cost $175, and servo mounts. If u don't want the Multiplex I will include 2 Hi Tech instead.
The flex shaft, drive dog, and prop nut is included and I will sweeten the deal with 1 prop of ur choice balanced and sharpened from my collection of over 50 props!!!!!!! How can u beat that!! Stuffing tube slips in and out of stinger but needs to be cut and shaped to ur needs, a set of cowl locks is included. I will include 8' of water line and 4' of tygon gas line too. If u want a gas bag I can send u a 250cc one with it. Please state u want the bag or not.