Michel

Hi

Need a little helping hand here , if someone could .please .

I,ve connected up the telemetry , double checked all the connections . The little blue LED on the senser station is flashing very quickly . Then , went in to the sensor program and . it says SENSORS NOT CONNECTED . I even tryed rebinding the system ,.............. nothing . Checked the instructions ,.................... it says nothing about this .

Not that I know anything about this , but , the wire for the DATA , going into the receiver , has the RED wire on the outside and the black wire on the opposite side with the yellow in the middle . ( is this right ? ) If the connecter is flipped around can the sensor atation be damaged ?. I don,t see any designation point for this terminal , except where it goes in to the sensor station .

Am I doing something wrong here ?

Any help would be appreciated

Thanks

Michel