RCU Forums - View Single Post - The "jitter "contnues
View Single Post
Old 11-04-2010, 05:10 PM
My Feedback: (31)
Join Date: Nov 2001
Location: Elverta, CA
Posts: 5,295
Likes: 0
Received 0 Likes on 0 Posts
Default RE: The


It’s very important to match the servos center and travel end-points in this circumstance. And yes opening the dead-band may calm things down a bit. I strongly suggest the use of an inline servo amp-meter to set-up travel volumes and match centers. This inexpensive tool is invaluable IMO, Hangar 9 offers these, I have three which I use simultaneously when setting up multi servo surfaces. And of course the Hitec Programmer is must have too for best results!