ORIGINAL: leonardor Hello. I just bought an Hitec HFP-10 servo programmer from a friend. This unit has the older software version V 1.03. and I'm wondering if this will work on todays servos like HS5625MG or HS5645MG? Thanks aloT!!
Yes, except fornewer functions of say"Overload protection Setting" and "Servo Resolution mode Setting",
which have been added into the newer HFP-20, full comparison and details:
<dt>
Hitec - HFP-20, HPP-21, HPP-21+, HMI = Servo Tester_Programmers for Hitec G2, digital and other servos.
These video may alsoassist:
HFP-10 & 20 advantage
HFP-10 video 1
HFP-10 Video 2
HFP-10 Video 3
HFP-10 Video 4 Linear setup multiple servo.
HFP-10 Video 5Inline RudderServoProgramming.
Refer also sub section "Servo - Digital Servo, Programmers and Software" at
Alan's Hobby, Model & RC FAQ Web Links
Alan T. </dt>