RCU Forums - View Single Post - are these blades any good for cp pro?
View Single Post
Old 03-31-2011, 01:18 PM
  #12563  
Aframomum
My Feedback: (10)
 
Join Date: Jun 2004
Location: Orlando, FL
Posts: 1,543
Likes: 0
Received 0 Likes on 0 Posts
Default RE: are these blades any good for cp pro?

Hi guys,

Well, its been storming and storming and storming down here. I think Glenn is also getting hammered by this thing too...its been a brutal 2 days of nonstop rain and wind. Looking forward to seeing the sun again sometime tomorrow.

John,

In that video it looked like your friends P51 was a bit tail heavy...looks like it kept pitching up and then did that low snap which ended it. Did the electronics fair well to be used in another plane? I know that most of my foamy warbirds end up very tail heavy and I usually have to put quite a bit of weight up front...it was a nice looking plane...a bit of 5 minute epoxy, a few evenings, and it should be ready for a remaiden.

So any more flights with your 500-1 or 450?

I am really looking forward to some nice mornings to hopefully get some flights in.

Mark from the soggy south.