Putting this giant scale yak together and one thing I hadn't noticed before: no slot for the throttle servo.
It's the new/original version (one that does NOT have the tunnel and the elev servos are in the fuse, not the stab).
There is a cutout for the (dual) rudder servo(s) but that's it. Anything forward of that is just a uncut piece of ply with no cutouts.
I've seen where one can make a bracket inside the engine box to mount it but I've never encountered this situation b4.
Then again, I've never finished a Nitroplanesbird b4 either.
Suggestions?