RCU Forums - View Single Post - How flat should a workbench be?
Thread: How flat should a workbench be?
View Single Post
Old 12-22-2011, 05:58 PM
  #12  
nefariousrc
Member
My Feedback: (2)
 
Join Date: Aug 2011
Location: SAN DIEGO, CA
Posts: 78
Likes: 0
Received 0 Likes on 0 Posts
Default RE: How flat should a workbench be?
Thanks guys.  To answer some of the questions:
I'm building a Goldberg Super Chippy.
I plan to use a ceiling tile as my build surface.


Thanks for the advise everybody.  I think I may just go for it and stuff a few sheets of paper in the center between the table & ceiling tile.

nefariousrc is offline  
Reply Like