RCU Forums - View Single Post - Fabricating rigid and lightweight push rods
Thread: Fabricating rigid and lightweight push rods
View Single Post
Old 01-02-2012 | 05:44 AM
  #11  
karolh
 
Joined: May 2002
Posts: 6,852
Received 33 Likes on 32 Posts
From: Mandeville, JAMAICA
Default RE: Fabricating rigid and lightweight push rods

ORIGINAL: pencon

" I'd be worried about the glue joint slipping out the end of the carbon tube . Carbon is very slippery stuff and epoxy doesn't stick too well to it " .
That would be my main concern also.

Karol
karolh is offline  
Reply Like