I was finishing up my SE ARF last night and when I attached the right wing at final assembly (after securing aluminum rod in place), I noticed a 1/16 gap between the wing TE and the fuse.

I can't seem to figure out why this happened, everything seems to line up and i don't have anything hindering the joints.

Also, I have read that people complain about the wings rubbing into the fuse. I have 1/16 sheets of foam rubber and was considering cuting the contour of the mating surface of the wing and glueing it to the wing for protection. Has anyone done this? Any recommendation on doing so? I don't think spacing the wings out 1/16 in will do any harm......plus it seems to fix my previous issue. :-)