Hello guys,

I have a seagull edge that uses 2 inverse servos (they must move in the opposite direction as they are installed in the opposite side of the tail).... Thus, I have one of the elevator plugged in the GEAR channel mixing with the elevator. However, I am installing a killswitch and I do not know how to install it in my receiver. I have a AR6100 with a DX7.
Thus I have:
Elevator : 1 servo elevator
Gear: 1 servo elevator (mixed with the elevator)
Aux 1: I would like to plug here the killswitch but I do not know how to mix it as I think this channel can only be used with flaps??? I do not understand.... could anyone help me?

I do not have installed any flaps in this plane thus I hope somebody can help me with a way of mixing the AUX1 so that I can turn on/off my kill switch with that...

thanks