I chose to go with JR 8711 HV's. Two of them should provide enough grunt for that all flying stab. Looking at the extra holes in my stab it looks as if my elevator might of originally had two pivot blocks. My kit came with one per side so thats what I am going with. I put larger than supplied washers on the bolts that go through the stab and into the block. Only as a peace of mind thing really.
It took a little time setting up the servo arms on the servo so they would not foul the fibreglass cover for the tail servo area. Push rods and clevises were all as standard. A couple of self adhesive alu clamps helped keep the servo wires out of the way.