RCU Forums - View Single Post - AR-6 Construction Thread
Thread
:
AR-6 Construction Thread
View Single Post
12-15-2012, 09:41 AM
#
68
sahartman21
Join Date: Nov 2007
Location: Fritch, TX
Posts: 2,060
Likes: 0
Received 0 Likes on 0 Posts
RE: AR-6 Construction Thread
The tail surface is shaped in the following pictures. Most of the actual shaping was done with a sanding block with coarse sandpaper (80 grit).
Attached Thumbnails
Reply
Like
sahartman21
View Public Profile
Send a private message to sahartman21
Find More Posts by sahartman21
View iTrader Profile