RCU Forums - View Single Post - New servo
Thread: New servo
View Single Post
Old 01-21-2013, 06:25 PM
  #8  
JoeMaxx
Senior Member
 
Join Date: Jan 2013
Location: Castle Rock, CO
Posts: 189
Likes: 0
Received 0 Likes on 0 Posts
Default RE: New servo


Foxy thanks for the additional advice.

This is my first 1/8 Scale Truggy so I would like to set it properly. I bought this back in December so it is shelf art until spring time.

The LHS handed me the HS-645MGservo to replace the stock Servo when I explained what I was putting it in.

I did find a Spektrum S6030 with 222/278 OZ of Torque from Horizon Hobbies reasonably priced at $72.99and will be replacing the stock radio system with a Spektrum DS200receiver so I can run this Truggy with the DX3C radio system this spring.

I realize this is more than the original poster wanted to spend and maybe he would want to follow your advice also. I included the part number of a reasonably priced Ultra High Torque Servo so he might be able to use this information.

http://www.horizonhobby.com/products...rque-SPMSS6030

Thanks again