RCU Forums - View Single Post - New Alpha 40 Prop Problem
Thread: New Alpha 40 Prop Problem
View Single Post
Old 02-09-2013 | 05:25 PM
  #1  
smitdoshi
Junior Member
 
Joined: Feb 2013
Posts: 9
Likes: 0
Received 0 Likes on 0 Posts
From: , CA
Default New Alpha 40 Prop Problem
Hello,
I am new to RC Community and just picked up my first RC Plane.
I got the Hanger 9 Alpha 40 after reading reviews and suggestions.

I got everything ready and when i turn on my Plane or try to my Prop comes off the plane and goes flying.

I have followed all the instructions from the manual (see link page 12) http://www.horizonhobby.com/pdf/HAN4400-Manual.pdf
I have tightened the screw as much as i can but when the engine is just about to turn on the prop goes flying. The NUT comes off completely
and i no longer know what to do.
Any suggestion??
i did notice the Nut is not threaded or anything not sure if that makes a difference?
Any help would be greatly appreciated.
Thank You
<br type="_moz" />
smitdoshi is offline  
Reply Like