RE: BJ Craft - Nuance 120
Well, I got the 120 all done and maidened it today. The verdict is 'pretty much like it's big brother' , smooth, predictable, accurate. I made up a sliding battery tray using some carbon tube I had laying around in my workshop, it took 6 hours to design and make up/install, with probably 70% of that in design and decision making. In use today as I was getting the cg spot on it was immediately apparent that it was time very well spent and made the whole excercise so much easier. I didn't get the chance to physically check the cg position during my visit to our flying site, but will get the measurement and post it up here for future reference.
The turnigy setup Im running is throwing up 1572W @ 59A using the APC 20x15, its bags of power and left 49% capacity in the 5k 20c 8s packs after a P13 today. Im totally sold on this one, which incidentally is for my son whos making a comeback to F3a after a few years off the sticks, lucky boy eh.......
A pic of the battery tray, any q's just ask.